Wet sensors (or humidity sensor troubles)

Intro Well there is no surprise: i went through a lot of temperature and humidity sensors. Some I already reported on, and some more i tried afterwards. And none seem to survive the exterior readout very well. The defects are mostly related to humidity, but not temperature. What happens when they fail: mostly the humidity saturates to 100%. Here is my most recently replaced one from outside, a BME280: After a while, the sensor reads… Continue reading

10002 I2C connectors

Intro In my first iteration of sensors I relied on wire connections between sensors and the actual node board. The result for a motion sensor and a temperature and humidity sensor looks like this The problem with that is that during sensor modules assembly run I spend quite a bit of time on the wiring. On top of that, the result is a mess of small wires inside a box. It makes it hard to… Continue reading

The basil speaks to me

Check out part 2, where the basil is watered automatically. Intro Part of my home automation system is monitoring the well-being of various other non-human species around the house. So i started with the plants. Since they are mostly fixed creatures and generally require only water input from humans, monitoring the soil humidity is a good start. How There are quite a few ways to measure how much water is in the soil, some of… Continue reading

10002 Temperature sensors?

Intro There is no doubt, that integrated temperature and humidity sensors are the way to go at the moment for my smart home project. I had quite a bit of look at a wide range of sensors and settled for the SI7021. Silabs has a bigger family – most likely the same chip binned on precision – so here are cheaper options to use if I ever want to go for an application that can do with… Continue reading