Tag: temperature

2 Comments

Wet sensors (or humidity sensor troubles)

  By , ,

Intro Well there is no surprise: i went through a lot of temperature and humidity sensors. Some I already reported on, and some more i tried afterwards. And none seem to survive the exterior readout very well. The defects are mostly related to humidity, but not temperature. What happens when they fail: mostly the humidity saturates to 100%. Here is my most recently replaced one from outside, a BME280: After a while, the sensor reads… Continue reading

No comments

10002 Temperature sensors?

  By , ,

Intro There is no doubt, that integrated temperature and humidity sensors are the way to go at the moment for my smart home project. I had quite a bit of look at a wide range of sensors and settled for the SI7021. Silabs has a bigger family – most likely the same chip binned on precision – so here are cheaper options to use if I ever want to go for an application that can do with… Continue reading

13 Comments

Bosch glue pen teardown

  By

Intro My cheap plug in hot glue gun died and looking for a replacement I found this: the Bosch GluePen What does it do? it’s a hot glue gun for 7 mm glue sticks that warms up in 15 seconds. Charges via micro USB. Much better than my old one that needed ~5 minutes to warm up for probably half a minute of gluing. I am very happy because of the fast warm up, wireless operation… Continue reading