Brief progress It is quite clear that my smart home project is going quite slow. It is not that I spent a lot a time on it, but that I have been pretty busy with other life things. But it is moving again now. Check out another batch of assembly. Motion sensors assembly Once I settled on the type of motion sensor and case, I designed some sensor PCBs . I made a small assembly… Continue reading
Motion sensor madness Picking the right one for my smart home project is not trivial. From left to right – Osram Nightlux, Ikea Molgan, Ebay sensors with sensitivity and timing adjusment (BISS001), smaller ebay sensor with no adjustment, another ebay sensor. As you can see I have looked at 2 different options: use a ready made sensor and fit it with a radio, or build my own. Ikea Molgan I hacked one a while ago –… Continue reading
Intro There is no doubt, that integrated temperature and humidity sensors are the way to go at the moment for my smart home project. I had quite a bit of look at a wide range of sensors and settled for the SI7021. Silabs has a bigger family – most likely the same chip binned on precision – so here are cheaper options to use if I ever want to go for an application that can do with… Continue reading
Intro My cheap plug in hot glue gun died and looking for a replacement I found this: the Bosch GluePen What does it do? it’s a hot glue gun for 7 mm glue sticks that warms up in 15 seconds. Charges via micro USB. Much better than my old one that needed ~5 minutes to warm up for probably half a minute of gluing. I am very happy because of the fast warm up, wireless operation… Continue reading
This article is part of my 1000² Smart Home project. Check out the Architecture and Software and then move on to Hardware. An most importantly, check the Lessons learned and why I did what I did. There are already some first results, connecting all parts of the system. Starting with a top down approach – what the system should do, it soon became clear that some devices will be custom and some will be off the shelf. Determining… Continue reading
This article is part of my 1000² Smart Home project. Check out the Architecture and Software and then move on to Hardware. An most importantly, check the Lessons learned and why I did what I did. There are already some first results, connecting all parts of the system. Intro There is plenty of software to use in home automation, but of course I decided to stay with open source and free options. In recent years there have been… Continue reading
This article is part of my 1000² Smart Home project. Check out the Architecture and Software and then move on to Hardware. An most importantly, check the Lessons learned and why I did what I did. There are already some first results, connecting all parts of the system. Some history A picture says 1000 words!* *inner voice dependent Which microcontroller? When I began this project, I was long given up on the ATMega and ATTtiny micro, with some… Continue reading
This article is part of my 1000² Smart Home project. Check out the Architecture and Software and then move on to Hardware. An most importantly, check the Lessons learned and why I did what I did. There are already some first results, connecting all parts of the system. What? This page covers things I have learned and why I did what I did in my 1000² project. Some experience, random calculations, opinions and thoughts. Battery philosophy So what… Continue reading
This article is part of my 1000² Smart Home project. Check out the Architecture and Software and then move on to Hardware. An most importantly, check the Lessons learned and why I did what I did. There are already some first results, connecting all parts of the system. Intro I have enjoyed building small home automation devices for many years, simple things that make life better or just cater for the lazy animal. The world has been dreaming… Continue reading
My experiences and recommendations for cheap electronic modules from China. Continue reading